全國熱線服務:
新聞資訊 Top label
- Revolutionizing High-Rise Building Care: The Essential Guide to Building Maintenance Units
- Advanced Locking Plate Technology: Revolutionizing Orthopedic Fracture Fixation
- Digital Pressure Sensors: Transforming Industrial Measurement and Process Control
- Digital Pressure Sensors: Transforming Industrial Measurement and Process Control
- Elevator Fall Arrest Anti-Fall Systems | Reliable Climber Safety Protection Solutions
- Steel Wire Rope Selection And Maintenance For Suspended Platforms
There are several manufacturing methods for seamless steel pipes
Seamless steel pipes can be divided into hot-rolled pipes, cold-rolled pipes,cold drawn tube, extruded tubes, etc.
Seamless steel pipe production and manufacturing method
Hot-rolled seamless pipes are generally produced on automatic pipe rolling units. The solid tube blank is inspected and surface defects are removed, cut into the required length, and then pierced through the tube blank.
The end face of the hole is centered, then sent to the heating furnace for heating, and punched on the punching machine. It continues to rotate and advance during piercing holes. Under the influence of the rollers and the end, the tube blank is hollow gradually, which is called gross pipe.
Then it is sent to the automatic pipe rolling machine to continue rolling. Finally, the wall thickness is evened by the leveling machine, and the diameter is determined by the sizing machine to meet the specification requirements. The use of continuous pipe rolling units to produce hot-rolled seamless steel pipes is a more advanced method.
If you want to obtain seamless pipes with smaller size and better quality, you must use cold rolling, cold drawing or a combination of the two. Cold rolling is usually carried out on a two-roll mill, and the steel pipe is rolled in an annular pass composed of a variable cross-section circular groove and a fixed conical head. Cold drawing is usually performed on a 0.5 to 100T single-chain or double-chain cold drawing machine.
The extrusion method is to place the heated tube blank in a closed extrusion cylinder, and the perforation rod and the extrusion rod move together to make the extrusion part extruded from the smaller die hole. This method can produce steel pipes with smaller diameters.
